TM-5-5420-202-20-3
M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60
TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 3 OF 4
OCTOBER 1985
TM-5-5420-202-20-3 - Page 1002 of 1060
TM 5-5420-202-20-3
COVER ASSEMBLY (ESCAPE HATCH) REPLACEMENT (EARLY MODEL) (Sheet 2 of 2)
NOTE
One soldier will be inside vehicle to
position cover and to hold handle (B).
2.
Rotate handle (B) clockwise.
3.
Lower jack and slide escape hatch (A) from
under vehicle.
INSTALLATION:
1.
Position escape cover (A) on hydraulic jack.
2.
Position hydraulic jack directly beneath hull
hull opening.
opening with cover in proper alinement with
NOTE
One soldier will be inside vehicle to
position cover and to hold handle (B).
3.
Raise cover (A) into position.
Hold lock handle (B) clockwise. Slight repositioning may be
needed to aline cover with hull opening. Use crowbar fpr repositioning.
4.
Release wire or rope to allow plungers (C) to engage hull lugs.
5.
Make sure plungers (C) fully engage hull lugs.
6.
Make sure seal (D) is fully seated around hull opening.
7.
Make sure handle (B) is in fully closed (counterclockwise) position.
8.
Remove jack.
End of Task
16-43
Back to Top
