TM-5-5420-202-20-3

M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 3 OF 4

OCTOBER 1985

TM-5-5420-202-20-3 - Page 371 of 1060

TM 5-5420-202-20-3

BASKET/CONTROL PANEL STARTING HARNESS REPLACEMENT (Sheet 3 of 5)

4.

5.

6.

7.

Using 7/16 inch socket, remove top screw

(H), lockwasher (J), and washer (K) securing

strap (L) at three locations. Leave bottom

screw (M) installed.

Using 7/16 inch socket, remove screws (N)

and lockwashers (P) securing clamps (Q) at

six locations.

Using 7/16 inch socket, remove screw (R)

and lockwasher (S) securing clamp (T) at

vehicle floor and at handle (U) of purge

pump (V).

Using fingers, slip wiring harness (W)

from behind straps (L) and out of clamps

(Q) and (T) and remove from vehicle.

NOTE

The illustration below shows locations of harness

assembly supporting straps and clamps and the routing

of the harness assembly.

Go on to Sheet 4

5-33

Change 7

10-296.31