TM-5-5420-202-20-3
M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60
TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 3 OF 4
OCTOBER 1985
TM-5-5420-202-20-3 - Page 41 of 1060
TM 5-5420-202-20-3
ENGINE GENERATOR REPLACEMENT (Sheet 3 of 8)
16.
17.
18.
19.
20.
13.
14.
15.
Using 1/2 inch wrench, loosen two
nuts (S) which hold U-bolt (T) to
cradle (U) until clamping bars
(V) are free.
Using diagonal cutting pliers,
cut lockwire (W).
Using 9/16 inch socket or 9/16
inch wrench, remove four screws
(X) and flat washers (Y).
Using 9/16 inch socket, remove
two nuts (Z) and flat washers
(AA).
Remove ground lead (N).
Remove bracket (AB), cradle (U),
and U-bolt (T) as one whole
assembly from generator (A).
Using screwdriver, loosen three boot
clamps (AC).
CAUTION
Boot (AD) is easily damaged. Be careful to
prevent ripping or puncturing boot (AD).
Slide boot clamps (AC) and boot (AD) over generator (A) to gain access fo removal
of mounting nuts.
Go on to Sheet 4
TA248949
10-8
Back to Top
