TM-5-5420-202-20-3
M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60
TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 3 OF 4
OCTOBER 1985
TM-5-5420-202-20-3 - Page 43 of 1060
TM 5-5420-202-20-3
ENGINE GENERATOR REPLACEMENT
INSTALLATION:
(Sheet 5 of 8)
1.
Make sure wooden blocks are positioned under right manifold heater.
WARNING
Generator (A) weighs approximately 100
pounds. Injury to personnel or damage to
equipment could result through careless
handling.
2.
Using two technicians, place generator (A) on wood blocks.
3.
Install six nuts (B) to drive adapter (C). Do not tighten nuts (B).
4.
Install three boot clamps (D) to boot (E).
5.
Install assembled boot
6.
Go
NOTE
Apply silicone compound to the inside of
the generator boot sealing surfaces before
installation.
(F) to generator (A).
Using two technicians, aline generator flange
(G) to six nuts (B). Rotate generator (A)
clockwise and push flange (G) onto six nuts
(B).
on to Sheet 6
TA248951
10-10
Back to Top
