TM-5-5420-202-20-3
M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60
TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 3 OF 4
OCTOBER 1985
TM-5-5420-202-20-3 - Page 51 of 1060
TM 5-5420-202-20-3
GENERATOR AIR EXHAUST PIPE AND HOSE REPLACEMENT (Sheet 3 of 4)
CLEANING AND INSPECTION:
WARNING
Dry cleaning solvent P-D-680 is toxic and flammable.
To prevent personal injury, wear
protective goggles and gloves and use only in a well-ventilated area. Avoid contact with skin,
eyes, and clothes and don't breathe vapors.
Do not use near open flame or excessive heat. The
flash point for Type #1 Dry Cleaning Solvent is 100°F (38°C) and for Type #2 is 138°F (50°C).
If you become dizzy while using cleaning solvent, get fresh air immediately and get medical aid.
If contact with eyes is made, wash your eyes with water and get medical aid immediately.
1.
2.
3.
4.
Using alcohol and rags, clean
hose. Inspect for cracks and
breaks. If hose is damaged,
replace hose.
Using dry cleaning solvent, clean all removed parts.
Using rags, wipe all removed parts dry.
Inspect mounting
missing.
INSTALLATION:
Apply
before
1.
2.
3.
hardware and pipe for damage.
Replace parts as required, if defective or
NOTE
silicone compound to the inside of the generator boot sealing surfaces
installation.
Position pipe (A) through engine shroud.
Assemble clamp (B) to pipe (A).
Using 1/2-inch socket, install two
screws (C), lockwashers (D), and
clamp (B) to pipe (A).
Go on to Sheet 4
10-16
TA248957
Back to Top
