TM-5-5420-202-20-3

M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 3 OF 4

OCTOBER 1985

  TM-5-5420-202-20-3 - Page 892 of 1060

TM 5-5420-202-20-3
SHOCK ABSORBER MOUNTING YOKE BUSHING REPLACEMENT (Sheet 1 of 4)
PROCEDURE INDEX
PROCEDURE
PAGE
Front and Middle Mounting Yoke Bushings Replacement
14-98.1
Rear Mounting Yoke Bushings Replacement
14-98.3
TOOLS: Hammer
SPECIAL TOOLS: Remover and replacer (Item 30.3, Chapter 3, Section I)
Bushing tool handle (Item 14, Chapter 3, Section I)
REFERENCE:
TM 5-5420-202-10
PRELIMINARY PROCEDURE: Remove shock absorber (page 14-95)
Front and Middle Mounting Yoke Bushings Replacement (Sheet 1 of 2)
REMOVAL:
NOTE
Replacement procedures are the same for the front and
middle mounting yoke bushings except where noted.
1.
2.
3.
4.
For ease of removal of middle mounting yoke
bushings, remove two track center guides at
position (A) (to rear of middle mounting yoke
(B) (TM
Position
bushing
Position
replacer
bushing
Remove
replacer
5-5420-202-10).
remover and replacer (C) on rear
(D) of mounting yoke (B).
handle (E) on remover and
(C) and, using hammer, drive rear
(D) out of mounting yoke (B).
handle (E) and remover and
(C).
Go on to Sheet 2
Change 4
14-98.1


Back to Top