TM-5-5420-202-20-3

M60A1 CHASSIS, TRANSPORTING; FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE MANUAL; VOLUME 3 OF 4

OCTOBER 1985

TM-5-5420-202-20-3 - Page 901 of 1060

TM 5-5420-202-20-3

GREASE ACTUATED TRACK ADJUSTING LINK REPLACEMENT (Sheet 6 of 7)

7.

8.

9.

10.

Install flat washer (J) and nut (K) on

threaded end of pin assembly (B).

Using 1-1/8 inch socket, tighten nut (K)

and align slot in nut (K) with hole in pin

assembly (B).

Using pliers, install new cotter pin (L).

Using wire rope assembly (M) and lifting

device, lower compensating idler arm (A).

13.

Using torque wrench, tighten capscrews (Q)

150-200 lb. ft. (203-271 N<m).

14.

Remove wire rope assembly (M) and

lifting device.

Aline slots of yoke (D) on adjusting

link (C) with bearing (N) on number 1

roadwheel support arm (P).

Using 15/16 inch socket and extension,

install and tighten two capscrews (Q) to

secure adjusting link (C) to bearing (N).

Go on to Sheet 7

TA250378

14-104