TM-5-5420-203-14
BRIDGE, ARMORED VEHICLE LAUNCHED, SCISSORING TYPE CLASS 60 & CLASS 70 ALUMINUM, 60 FOOT SPAN; FOR M48A5 AND M60 LAUNCHER
TECHNICAL MANUAL; OPERATOR’S, UNIT, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE
JUNE 1991
TM-5-5420-203-14 - Page 69 of 298
TM 5-5420-203-14
c.
Assembly of the Bridge Separated into Eight Sections - CONT
(10) Installation of Center Section Traverse Braces
NOTE
The pintles of the transverse braces are threaded. The brace maybe installed on either side
of the clip angles.
(a)
(b)
Using four bolts (l), install first center transverse brace (2) to male and female center
sections (3) and (4). Tighten bolts (l).
Using four bolts (5), install second center transverse brace (6) to male and female center
sections (3) and (4). Tighten bolts (5).
(11) Assembly of Far-Shore Center Sections.
(a) Place crib timbers in front of the completed half of the bridge.
(b) Place a male center section on the left timbers and a female center section on the right
timbers. Aline the two center sections with the assembled near-shore half of the bridge.
Allow 1 ft of separation between the assembled half of the bridge and the center sections.
2-19
Back to Top
