TM-5-5420-228-24

LAUNCHER HYDRAULICS SYSTEM M48A5/M60A1 TANK CHASSIS, TRANSPORTING: FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL, DIRECT SUPPORT AND GENERAL SUPPORT; MAINTENANCE MANUAL

AUGUST 1985

TM-5-5420-228-24 - Page 379 of 750

TM 5-5420-228-24

LOCKING CYLINDER HOSE ASSEMBLIES (EA1, CP3, CP4 and CS) AND HYDRAULICS

RE PLACEMENT (Sheet 3 of 4)

8.

9.

10.

11.

1.

2.

3.

4.

5.

6.

7.

Using adjustable wrench to hold tee (F), use

1-1/4 inch wrench to install hose assembly

“CS” (B).

Using 1-1/4 inch wrench on nut (H), use

11/16 inch open end wrench to connect hose

assembly “CP3” (L).

Using adjustable wrench on elbow (A), use

1-1/4 inch wrench to connect hose assembly

“CS” (B).

Manually install nuts (C), flat washers

(D), and new preformed packings (E) onto

tees (F).

Using adjust able wrench, install tees (F).

Aline tees (F) as shown.

Install sleeve (G) into nut (H).

Using 1-1/4 inch wrench, install nut (H) and

sleeve (G) as an assembly on tee (F).

Using pipe wrench, install coupling (J).

Using pipe wrench on coupling (J), use

adjustable wrench to install and aline elbow

(K), as shown.

Using adjustable wrench on tee (F), use

adjustable wrench to connect hose

assemblies “EA1” (M) and “CP4” (N).

Using adjust able wrench on elbow (K), use 15/16 inch wrench to install hose assembly “

EA

1

”

(M).

Go on to Sheet 4

3-182

TA251579