TM-5-5420-228-24

LAUNCHER HYDRAULICS SYSTEM M48A5/M60A1 TANK CHASSIS, TRANSPORTING: FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL, DIRECT SUPPORT AND GENERAL SUPPORT; MAINTENANCE MANUAL

AUGUST 1985

TM-5-5420-228-24 - Page 372 of 750

TM 5-5420-228-24

HOLD DOWN CYLINDER HOSE ASSEMBLIES (CU1, CU2, CV1 THRU CV4) AND HYDRAULICS

11.

12.

13.

14.

15.

16.

17.

Using 13/16 inch wrench on adapter (T), use

7/8 inch wrench to remove hose assembly

“CV4” (R).

Using 13/16 inch wrench, remove adapter

(T) and collar (U).

Using adjustable wrench on elbow (V), use

7/8 inch wrench to remove hose assembly

“CV3” (Q).

Remove hose assemblies (Q) and (R) from

armor (W).

Using adjustable wrench, remove elbow (V)

nipple (X), and elbow (Y) as an assembly.

Place nipple (X) in a vise.

Using adjust able wrench, remove elbow (Y).

Using adjustable wrench, remove elbow (V) and collar [Z) from nipple

INSTALLATION:

NOTE

Remove caps and plugs as necessary during installation.

Before installation, use pipe tape on all male threads. Start

tape on second thread so tape will not enter hydraulic

system.

1.

Holding adapter (A) with 1-1/4 inch wrench,

use 7/8 inch wrench to connect hose

assembly “CU1” (B).

2.

Holding adapter (C) with 1-1/4 inch wrench,

use 7/8 inch wrench to connect hose

assembly “CU2” (D).

(x).

Go on to Sheet 4

TA251572

3-175