TM-5-5420-228-24

LAUNCHER HYDRAULICS SYSTEM M48A5/M60A1 TANK CHASSIS, TRANSPORTING: FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL, DIRECT SUPPORT AND GENERAL SUPPORT; MAINTENANCE MANUAL

AUGUST 1985

TM-5-5420-228-24 - Page 365 of 750

TM 5-5420-228-24

TONGUE CYLINDER HOSE ASSEMBLIES (CT, DA3, AND DA4) AND HYDRAULICS REPLACEMENT

(Sheet 3 of 4)

3.

4.

5.

6.

7.

8.

9*

10.

11.

12.

Using adjustable wrench to hold tee (C), use

1-1/4 inch wrench to tighten nut (D).

Using 1-1/4 inch wrench on hose assembly

“DA3” (G) and 1-1/4 inch wrench on adapter

(A), install hose (G).

Using 1-1/4 inch wrench on hose assembly “CT” (H) and adjustable wrench on tee (C),

install hose assembly (H).

Using 1-1/4 inch wrench on hose assembly “DA4” (J) and adjustable wrench on tee (C),

install hose assembly (J).

Using 1-1/4 inch wrench on hose assembly

“CT” (H) and adjustable wrench on elbow

(K), install hose assembly (H).

Manually install nuts (L), flat washers

(M) and new preformed packings (N) on

elbows (P).

Manually install two elbows (P) in

vehicle and sine elbows as shown.

Using adjustable wrench to hold elbows (P),

use 1-1/4 inch wrench to tighten nuts (L).

Using 1-1/4 inch wrench on hose assemblies

(J) and (G) and adjustable wrench on

elbows (P), install hose assembly “DA4” (J)

and hose assembly “DA3” (G).

Using 1-1/4 inch wrench on hose assembly

“CP1” (Q) and adjustable wrench on elbow

(R), install hose assembly (Q).

Go on to Sheet 4

3-168