TM-5-5420-228-24

LAUNCHER HYDRAULICS SYSTEM M48A5/M60A1 TANK CHASSIS, TRANSPORTING: FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL, DIRECT SUPPORT AND GENERAL SUPPORT; MAINTENANCE MANUAL

AUGUST 1985

TM-5-5420-228-24 - Page 361 of 750

TM 5-5420-228-24

OVERHEAD CYLINDER RETURN HOSE ASSEMBLY (F) REPLACEMENT (Sheet 2 of

2)

INSTALLATION:

1.

2.

3.

4.

5.

6.

7.

8.

NOTE

Before installation, use pipe tape on all

male threads. Start tape on second thread

so tape will not enter hydraulic system.

Using adjustable wrench to hold elbow (A),

use 1-1/4 inch wrench to install hose

assembly “F” (B).

Manually place elbow nut (C), flat washer

(D) and new preformed packing (E) on

elbow (F).

Manually install elbow (F) on vehicle.

Aline elbow (F) as shown.

Using adjustable wrench to hold elbow (F),

use 1-1/4 inch wrench to tighten elbow nut

(c).

Using adjustable wrench to hold elbow (F),

use 1-1/4 inch wrench to install hose

assembly “F” (B).

Bleed hydraulic system (page 3-72).

Check for hydraulic leaks and correct as

necessary.

Service hydraulic reservoir as needed (LO 5-

5420-202-12).

TA251563

End of Task

3-164