TM-5-5420-228-24

LAUNCHER HYDRAULICS SYSTEM M48A5/M60A1 TANK CHASSIS, TRANSPORTING: FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL, DIRECT SUPPORT AND GENERAL SUPPORT; MAINTENANCE MANUAL

AUGUST 1985

TM-5-5420-228-24 - Page 369 of 750

TM 5-5420-228-24

OVERHEAD CYLINDER HOSE ASSEMBLIES (DA5 AND DA6) AND HYDRAULICS REPLACEMENT

(Sheet 3 of 3)

7.

8.

Using 1-1/4 inch wrench on adapter (E), use

7/8 inch wrench to connect hose assembly

“CU1” (H).

Using 1-1/4 inch wrench on adapter (E), use

7/8 inch wrench to connect hose assembly

“CU2” (J).

9.

10.

11.

12.

13.

Manually

(L), and

install nuts (K), flat washers

new preformed packings (M )

onto elbows (N).

Manually install and aline elbows (N).

Using adjust able wrench on elbows (N), use

1-1/4 inch wrench to tighten nuts (K).

Using adjust able wrench on elbow (N), use 1-

1/4 inch wrench to connect hose assembly

“DA5” (F).

Using adjustable wrench on elbow (N), use 1-

1/4 inch wrench

“DA6” (G).

14.

15.

16.

17.

18.

End

Using 1-1/4 inch wrench, connect hose assembly “DA2” (P).

Bleed hydraulic system (page 3-72).

Check for hydraulic leaks and correct as necessary.

Install front quadrant (page 3-46).

Service hydraulic reservoir (LO 5-5420-202-12).

of Task

to connect hose assembly

TA251570

3-172