TM-5-5420-228-24

LAUNCHER HYDRAULICS SYSTEM M48A5/M60A1 TANK CHASSIS, TRANSPORTING: FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL, DIRECT SUPPORT AND GENERAL SUPPORT; MAINTENANCE MANUAL

AUGUST 1985

TM-5-5420-228-24 - Page 378 of 750

TM 5-5420-228-24

LOCKING CYLINDER HOSE ASSEMBLIES (EA1, CP3, CP4 and CS) AND HYDRAULICS

REPLACEMENT (Sheet 2 of 4)

6.

7.

8.

9.

10.

11.

12.

13.

14.

15.

Holding tee (C) with adjustable wrench, use

1-1/4 inch wrench to loosen nut (K).

Using adjustable wrench, remove tee (C),

nut (K), flat washer (L), and preformed

packing (M). Throw preformed packing (M)

away.

Using 1-1/4 inch wrench, remove nut (H) and

sleeve (N) as an assembly from tee (G).

Push sleeve (N) out of nut (H).

Using adjustable wrench, remove tee (G), nut

(P), flat washer (Q), and preformed packing

(R). Throw preformed packing (R) away.

Using adjustable wrench on elbow (F) and

pipe wrench on coupling (S), remove elbow

(F).

Using pipe wrench, remove coupling (S).

Using adjustable wrench on elbows (T), use

7/8 inch wrench to remove hose assemblies

“CP3” (J) and “CP4” (D).

Using adjustable wrench to hold elbows (T),

use 7/8 inch wrench to loosen nuts (U).

Using adjustable wrench, remove two elbows

(T), nuts-(U), flat washers (V), and preformed

packings (W). Throw preformed packings

(W) away.

INSTALLATION:

NOTE

Before installation, use pipe tape on all

so tape will not enter hydrauIic system.

Go

on to Sheet 3

male threads. Start tape on second thread

TA251578

3-181