TM-5-5420-228-24

LAUNCHER HYDRAULICS SYSTEM M48A5/M60A1 TANK CHASSIS, TRANSPORTING: FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL, DIRECT SUPPORT AND GENERAL SUPPORT; MAINTENANCE MANUAL

AUGUST 1985

TM-5-5420-228-24 - Page 581 of 750

TM 5-5420-228-24

DRIVER’S HATCH NIGHT VIEWER LATCH REPAIR (Sheet 3 of 10)

NOTE

Insert 1/8 inch punch in tooling hole in flange of shaft (N).

Push back on punch against spring pressure to aid in removal

of pin

(P).

Have one person hold punch while another person

does step

10. Using 3/16 inch punch

(P) out of handle (Q).

turn.

10.

and hammer, drive pin

11. Using hand, work handle (Q) off shaft (N).

12. Carefully relieve pressure of spring by allowing

1/8 inch punch to come toward you about 1/4

If handle

need not

NOTE

(Q), lever (R), and spring (S) were operating good, you

disassemble them. Proceed to step 15.

13.

14.

Place lever (R) in vise and, using 1/8 inch punch and hammer, drive pin out of lever (R), being

careful not to loosen spring (S).

Remove lever (R), spring (S), and handle (Q).

Go on to Sheet 4

3-272

TA251769