TM-5-5420-228-24

LAUNCHER HYDRAULICS SYSTEM M48A5/M60A1 TANK CHASSIS, TRANSPORTING: FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL, DIRECT SUPPORT AND GENERAL SUPPORT; MAINTENANCE MANUAL

AUGUST 1985

TM-5-5420-228-24 - Page 587 of 750

TM 5-5420-228-24

DRIVER’S HATCH NIGHT VIEWER LATCH REPAIR

23, If operating push rod parts were not disassembled,

24. Start nut (S) onto rod (T) with locking collar

first. Run it on to about 1/4 inch of end of

threads. Use 1/2 inch wrench if locking collar

is tight. Use vise if necessary.

25. Place sleeve (U) on rod (T).

(Sheet 9 of 10)

proceed to step 29.

26. Insert pivot (V) in plunger (W). Using hammer, drive in two pins (X) through pivot (V).

NOTE

Position pins (X) through pivot (V)

through pivot equally on both sides.

so that they each stick

27. Pivot (V) has flat faces on two surfaces. Rotate pivot so smaller flat face is facing sleeve (U).

Slide pivot on rod (T).

28. Using socket, install nut (Y) while holding nut (S) with 1/2 inch wrench.

Go on to Sheet 10

TA251775

3-278