TM-5-5420-228-24

LAUNCHER HYDRAULICS SYSTEM M48A5/M60A1 TANK CHASSIS, TRANSPORTING: FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL, DIRECT SUPPORT AND GENERAL SUPPORT; MAINTENANCE MANUAL

AUGUST 1985

TM-5-5420-228-24 - Page 584 of 750

TM 5-5420-228-24

DRIVER’S HATCH NIGHT VIEWER LATCH REPAIR (Sheet 6 of 10)

5.

Insert shaft (F) with offset threaded portion in

down position (nearest support (A) and tooling

hole facing you).

6.

Line up loop of spring (D) with holes of sleeve

(E) and shaft (F).

7.

Place washer (G) on pin (H) and insert pin from

the back side.

8.

Insert new cotter pin (J) through hole in pin

(H).

9.

Using screwdriver and pliers, bend legs of cotter pin (J).

NOTE

10.

11.

12.

If handle was not disassembled, go to step 13.

Place lever (K) on bench and, using hammer,

drive pin (L) partly through lever.

Place handle (M) on bench and position spring

(N) in recess of handle and lever (K).

Using hammer, drive pin (L) through lever (K)

and handle (M).

Go on to Sheet 7

TA251772

3-275