TM-5-5420-228-24

LAUNCHER HYDRAULICS SYSTEM M48A5/M60A1 TANK CHASSIS, TRANSPORTING: FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL, DIRECT SUPPORT AND GENERAL SUPPORT; MAINTENANCE MANUAL

AUGUST 1985

  TM-5-5420-228-24 - Page 724 of 750

TM 5-5420-228-24
GENERAL MAINTENANCE - Continued
Single Fastener Double-Twist Safety Wiring
TOOLS: Slip joint pliers
Diagonal cutting pliers
SUPPLIES: Lockwire
1.
Using diagonal cutting pliers, cut piece of lockwire about 24 inches long.
4.
5.
6.
Run one leg of wire through drilled hole (B) in
plate.
Using slip joint pliers, twist wire at least six
times.
Using diagonal cutting pliers, cut wire leaving a
pigtail from 1/4 to 1/2 inch long.
2.
3.
Run wire through drilled bolt head (A),
keeping length of free wire ends the same.
Using slip joint pliers, twist wire until wire
twist almost reaches drilled hole (B) in plate.
7.
Bend pigtail back under to prevent it from
becoming a snag.
End of Task
C-30
TA251298


Back to Top