TM-5-5420-228-24

LAUNCHER HYDRAULICS SYSTEM M48A5/M60A1 TANK CHASSIS, TRANSPORTING: FOR BRIDGE, ARMORED-VEHICLE-LAUNCHED; SCISSORING TYPE, CLASS 60

TECHNICAL MANUAL; ORGANIZATIONAL, DIRECT SUPPORT AND GENERAL SUPPORT; MAINTENANCE MANUAL

AUGUST 1985

TM-5-5420-228-24 - Page 715 of 750

TM 5-5420-228-24

GENERAL MAINTENANCE - Continued

Spring Pin Removal

TOOLS: Ball peen hammer

Drive pin punch

NOTE

Drive pin punch used to remove

spring pin must be about 1/32

inch smaller than pin hole.

1.

Put drive pin punch into spring hole

and center on pin (A).

2.

Using hammer, lightly tap drive pin punch

until pin (A) is driven out of hole.

End of Task

TA251291

C-21