TM-9-1290-365-24-P
PALADIN MUZZLE VELOCITY SYSTEM M93 UPGRADED
TECHNICAL MANUAL; UNIT, DIRECT SUPPORT, AND GENERAL SUPPORT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LIST
OCTOBER 2000
TM-9-1290-365-24-P - Page 192 of 334
ARMY TM 9-1290-365-24&P
D.4.6.4 REMOVAL OF TRANSCEIVER. Refer to Figures D-1, D-2. and 0-3.
Detector output pin must be grounded at all times.
a. Remove RF cable(4) lAW para. D.4.6.3.
b. Remove six screws (6), six lock washers (7) and six flat washers (8) which attach the transceiver
(5) to the antenna base.
c. Short circuit the transceiver’s detector output using bus wire QQ-W-343/S-22S1T by first
connecting wire to the ground lug, and then to the detector output pin.
d. Using soldering iron, disconnect one wire from detector output pin, and two wires from the ground
lug.
e. Using soldering iron, disconnect three wires from the oscillator input pin and ground lug.
f.
Place plastic cap for SMA connector on the transceiver output connector.
g. Remove transceiver (5) and place it in an antistatic bag. Do not remove shorting bus wire.
D.4.6.5 REMOVAL OF GASKET. Refer to Figures D-1, D-2, and D-3.
a. Gently peel gasket (24) from the surface of the transceiver assembly (1).
b. Remove remaining gasket material with a soft hand tool in order not to nick or scratch housing
surface.
D.4.6.6 REMOVAL OF DOPPLER AMPLIFIER CCA. Refer to Figures D-1, D-2, and D-3.
a. Remove eight screws (11), eight lock washers (12) and eight flat washers (13) from CCA cover
(9).
b. Remove Cover (9).
c. Tag and identify six wires connected to CCA.
d. Using soldering iron, disconnect six wires.
e. Remove 12 screws (15), 12 lock washers (16) and 12 flat washers (17) from CCA (10).
f.
Remove CCA (10) from transceiver assembly (1) and place it in antistatic bag.
D.4.6.7 REMOVAL OF POWER SUPPLY MODULE. Refer to Figure D-1, D-2, and D-3.
a. Loosen four screw locks (18) securing connectors (19,20) to the module (14).
b. Remove eight screws (21), eight lock washers (22) and eight flat washers (23) from module (14).
c. Remove module (14) from transceiver assembly (1) and place it in antistatic bag.
D.4.6.8 REMOVAL OF MVP CCA.
D.4.6.8.1 Configuration AY6707292-3 and AY6707292-4 Refer to Figures D-1. and D-2.
a. Loosen two screws of connector (27).
b. Loosen two screws of connector (26).
Back to Top
