TM-9-2320-209-20-3-1
2½-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)
TECHNICAL MANUAL; TROUBLESHOOTING; ORGANIZATIONAL LEVEL; VOLUME 3 OF 3; PART 1 OF 4
MAY 1981
TM-9-2320-209-20-3-1 - Page 54 of 830
TM 9-2320-209-20-3-1
1.
2.
3.
4.
5.
6.
7.
NOTE
Make sure all surfaces to which gaskets mate are clean.
Coat both gaskets with a thin coat of engine oil before
putting them back.
Check oil filter repair kit for one small gasket, one large gasket, and one
filter element.
Put small gasket (1) on center post (2) and slide gasket to top end of center
post .
Put center post (2) through hole at top of filter body ( 3).
Put spring (4) in cup (5) and set cup into recessed hole at top end of filter
element ( 6).
Be sure cup is properly seated in filter element.
Put threaded end of center post (2) through assembled spring (4) , cup (5),
and filter element (6) .
Slide filter element (6) up center post (2) into filter body (3) until it seats
against top of filter body.
Large gasket (7) will be used when the filter
assembly is put back on engine.
Put in cotter pin (8) and bend open ends.
GO TO FRAME 2
2-16
Back to Top
