TM-9-2320-209-20-3-1
2½-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)
TECHNICAL MANUAL; TROUBLESHOOTING; ORGANIZATIONAL LEVEL; VOLUME 3 OF 3; PART 1 OF 4
MAY 1981
TM-9-2320-209-20-3-1 - Page 57 of 830
TM 9-2320-209-20-3-1
2-6.
CRANKCASE BREATHER TUBE REMOVAL AND REPLACEMENT.
TOOLS :
7/16-inch combination box and 6-inch extension
open end box wrench
Ratchet
3/4-inch combination box and Flat-tip screwdriver
open end box wrench
7/16-inch open end wrench
3/4-inch open end wrench
9/16-inch socket wrench
SUPPLIES : None
PERSONNEL: One
5/8-inch open end wrench
(2)
1 3/16-inch open end wrench
3/8-inch open end wrench
EQUIPMENT CONDITION : Truck parked, engine
Preliminary Procedure. Open hood and right
TM 9-2320-209-10.
b.
Removal.
off and cool, handbrake set.
side panel. Refer to
(1) Breather tube (trucks with engines
LD
465-1 and LD 465-lC) .
FRAME 1
1.
Using 5/8-inch open end wrench and 3/4-inch combination box and open end
box wrench, hold adapter fitting (1) and unscrew and take off tube nut (2) .
Unscrew and take off adapter fitting.
2.
Using 7/16-inch wrenches,
unscrew and take off capscrew (3) and nut (4) .
Spread open and take off clamp (5) .
3.
Using screwdriver,
loosen two hose clamps (6). Pull off hose (7) with crank-
case breather tube (8) from breather tube adapter (9) .
4.
Take off two hose clamps (6) and hose (7) from crankcase breather tube (8) .
END OF TASK
2-19
Back to Top
