TM-9-2320-209-20-3-1
2½-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)
TECHNICAL MANUAL; TROUBLESHOOTING; ORGANIZATIONAL LEVEL; VOLUME 3 OF 3; PART 1 OF 4
MAY 1981
TM-9-2320-209-20-3-1 - Page 51 of 830
TM 9-2320-209-20-3-1
Section III.
ENGINE LUBRICATION SYSTEM
2-5.
OIL FILTER ELEMENT REMOVAL AND REPLACEMENT.
NOTE
The following tasks are the same for both oil filters.
TOOLS :
7/16-inch open end wrench
Drain pan
7/8-inch wrench
7/8-inch socket
Torque wrench, 150 pound-feet capacity
6-inch long round nose pliers
SUPPLIES : Oil filter kit, NSN 2940-00-884-4801
Lubricating oil, ICE, OE/HDO 10, MIL-L-2104
PERSONNEL :
One
EQUIPMENT CONDITION :
Truck parked, engine off, handbrake set.
Preliminary Procedure. Open hood and left side panel. Refer to
TM 9-2320-209-10.
b.
Removal.
1.
Place drain pan under engine to catch oil from oil fitting drain plug ( 1).
2.
Using 7/16-inch wrench,
unscrew and take out drain plug ( 1) and wait
until oil stops draining.
3.
Check drained oil for water, dirt or pieces of metal. If any of these are
found, tell direct support maintenance.
GO TO FRAME 2
2-13
Back to Top
