TM-9-2320-209-20-3-1
2½-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)
TECHNICAL MANUAL; TROUBLESHOOTING; ORGANIZATIONAL LEVEL; VOLUME 3 OF 3; PART 1 OF 4
MAY 1981
TM-9-2320-209-20-3-1 - Page 50 of 830
TM 9-2320-209-20-3-1
c.
Replacement.
WARNING
1.
2.
3.
4.
5.
Do not put fingers between rear mounting support (1)
and bracket ( 2). Jack may slip, causing severe injury
to personnel.
Put upper resilient mount (3) between rear mounting support (1) and bracket
(2) and aline holes.
Using jack, carefully lower rear of engine.
Put flat washer and bolt (4) through rear mounting support (1) , upper
resilient mount ( 3) , and bracket ( 2) as shown.
Put lower resilient mount (5) and flat washer (6) on bolt (4) . Using 15/16-
inch and 3/4-inch wrenches, screw on and tighten locknut (7) .
Put accelerator linkage (8) through hole in bracket ( 9). Using 1/2-inch
wrenches, screw on and tighten nut ( 10).
NOTE
Follow-on Maintenance Action Required:
Close hood and both side panels. Refer to TM 9-2320-209-10.
END OF TASK
2-12
Back to Top
