TM 9-2320-209-20-3-1
CHAPTER
CLUTCH SYSTEM GROUP
3
MAINTENANCE
Section I. SCOPE
3-1. EQUIPMENT ITEMS COVERED.
This chapter gives equipment maintenance pro-
cedures for the clutch linkage assembly for which there are authorized corrective
maintenance tasks at the organizational maintenance level.
3-2. EQUIPMENT ITEMS NOT COVERED .
All equipment items for which corrective
maintenance is authorized at the organizational maintenance level are covered in this
chapter.
Section II.
CLUTCH LINKAGE ASSEMBLY
3-3.
CLUTCH CONTROL AND LINKAGE REMOVAL , REPAIR, REPLACEMENT,
AND ADJUSTMENT .
TOOLS :
Prybar
6-inch ruler
9/16-inch wrench (2) Drift pin punch
3/4-inch wrench (2) Pliers
Flat-tip screwdriver
SUPPLIES : Chalk, SS-C-266F
PERSONNEL :
One
EQUIPMENT CONDITION :
Truck parked, engine off, handbrake set, wheels
chocked.
a.
Preliminary Procedures.
(1) Take off accelerator linkage. Refer to para 4-29.
(2) On trucks with transmission power takeoff, tell direct support mainte-
nance to take off power takeoff.
3-1