TM-9-2320-209-20-3-1

2½-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; TROUBLESHOOTING; ORGANIZATIONAL LEVEL; VOLUME 3 OF 3; PART 1 OF 4

MAY 1981

  TM-9-2320-209-20-3-1 - Page 74 of 830

TM 9-2320-209-20-3-1
FRAME 2
1.
Screw nut (1) onto rod (2) and then screw clevis (3) onto rod.
2.
Screw clevis (3) in or out on rod (2) as necessary to set length. Set length
between clevis ( 3 and 4) hole centers to 14 1/8 inches as shown.
3.
Using 3/4-inch wrenches,
hold clevis (3) and tighten nut (1) .
4.
Put clutch throwout shaft lever (5) on clutch throwout shaft (6). Center line
must be one spline to rear of shaft center line as shown.
GO TO FRAME 3
TA 04725 9
3-8


Back to Top