TM-9-2320-209-20-3-1

2½-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; TROUBLESHOOTING; ORGANIZATIONAL LEVEL; VOLUME 3 OF 3; PART 1 OF 4

MAY 1981

  TM-9-2320-209-20-3-1 - Page 75 of 830

TM 9-2320-209-20-3-1
1.
Push lower end of clutch throwout shaft lever (1) forward until resistance is
noted. Using scale, measure distance from center of lever bottom hole to
transmission flange as shown.
NOTE
Measurement should be approximately 3 1/4 inches.
2.
If measurement is not approximately 3 1/4 inches, take off lever (1) and turn
it one spline at a time until measurement is correct.
3.
Using 3/4-inch wrenches,
hold bolt (2) and tighten nut (3) .
4.
Join rod
Locknut
5.
Join rod
NOTE
Before joining rod assembly (4) to control lever (5) , put
lever in up position.
assembly (4) to control lever (5) with bolt (6) and locknut (7) .
must be on transmission side as shown.
assemblv (4) to clutch throwout shaft lever (1) using pin (8) . Head
“o
-
f pin must be on transmission side as shown. Using prybar, pry pin in
clevis ( 9) until head of pin seats against clevis.
6.
Using 3/4-inch wrenches, tighten locknut (7).
Go TO FRAME 4
3-9


Back to Top