TM-9-2320-209-20-3-1

2½-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; TROUBLESHOOTING; ORGANIZATIONAL LEVEL; VOLUME 3 OF 3; PART 1 OF 4

MAY 1981

TM-9-2320-209-20-3-1 - Page 711 of 830

TM 9-2320-209-20-3-1

CHAPTER 9

TRANSMISSION TRANSFER SYSTEM GROUP MAINTENANCE

Section I. SCOPE

9-1. EQUIPMENT ITEMS COVERED.

This chapter gives equipment maintenance pro-

cedures for the transmission transfer control and linkage assembly for which there

are authorized corrective maintenance tasks at the organizational maintenance level.

9-2. EQUIPMENT ITEMS NOT COVERED.

All equipment items for which corrective

maintenance is authorized at the organizational maintenance level are covered in this

chapter.

Section II.

TRANSMISSION TRANSFER CONTROL AND LINKAGE ASSEMBLY

9-3. TRANSMISSION TRANSFER CONTROLS AND LINKAGE WITH POWER TAKEOFF

REMOVAL AND REPLACEMENT (TRUCKS M49A1C, M49A2C, M50A1, M50A2,

M50A3, M756A2, and M764).

NOTE

Procedures given are the same for both air actu-

ated positive lockup transmission transfer with

power takeoff, and non air actuated positive

lockup transmission transfer with power takeoff,

except where noted.

TOOLS:

3/4-inch socket wrench Vise grip pliers

3/4-inch open end wrench

Small hammer

18-inch ruler 13/16-inch open end wrench

Needle nose pliers 5/8-inch wrench

Drift punch

SUPPLIES:

None

PERSONNEL: T

WO

EQUIPMENT CONDITION:

Truck parked, engine off, handbrake set.

a.

Preliminary Procedure. Remove intermediate and rear tunnels. Refer to

Part 3, para 18-5.

b.

Removal of Transmission Shift Lever and Linkage (Trucks M756A2 and M764).

Refer to para 9-4.

9-1