TM-9-2320-209-20-3-1

2½-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; TROUBLESHOOTING; ORGANIZATIONAL LEVEL; VOLUME 3 OF 3; PART 1 OF 4

MAY 1981

TM-9-2320-209-20-3-1 - Page 734 of 830

TM 9-2320-209-20-3-1

9-4. TRANSMISSION TRANSFER CONTROLS AND LINKAGE (WITHOUT POWER

TAKEOFF) REMOVAL, REPAIR, AND REPLACEMENT.

NOTE

Procedures given are the same for both air

actuated positive lockup transmission transfer

and transmission transfer without air actuated

positive lockup, except where noted.

TOOLS:

3/8-inch wrench

7/16-inch wrench

9/16-inch wrench (2)

3/4-inch wrench (2)

3/4-inch socket wrench

clamp

Vise grip pliers

Wood blocks

8-inch extension

Vise

Ruler

Rolling head prybar

9/16-inch socket wrench

Small hammer

Jack

Retaining ring pliers

SUPPLIES:

Solvent, dry cleaning, type II (SD-2), Fed. Spec P-D-680

PERSONNEL: T

W O

EQUIPMENT CONDITION:

Truck parked, engine off, handbrake set.

On transmission

positive lockup,

or reverse shift

CAUTION

transfers without air actuated

removal of transmission transfer

linkage requires complete

adjustment of reverse-shift linkage. This is to

make sure that double sprag overrunning

clutch

works correctly. Refer to para 9-6.

a.

Preliminary Procedures. Remove cab tunnels. Refer to Part 3, para 18-5.

9-24