TM-9-2320-209-20-3-1

2½-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; TROUBLESHOOTING; ORGANIZATIONAL LEVEL; VOLUME 3 OF 3; PART 1 OF 4

MAY 1981

TM-9-2320-209-20-3-1 - Page 761 of 830

TM 9-2320-209-20-3-1

9-7. TRANSMISS1ON TRANSFER OUTPUT COVER SEAL AND AIR VENT REMOVAL

AND REPLACEMENT.

TOOLS:

Cross-tip screwdriver (Phillips type)

9/16-inch wrench

7/16-inch wrench

SUPPLIES:

Seal, transfer output cover

Solvent, dry cleaning, type II (SD-2) , Fed. Spec P-D-680

PERSONNEL: One

EQUIPMENT CONDITION:

Truck parked, engine off, handbrake set.

Preliminary Procedure. Remove intermediate and rear tunnel. Refer to

Part 3, para 18-5.

b.

Removal.

CAUTION

Cover holds down poppet ball for shifter shaft

and will spring up when bolts are loosened. Do

not let spring fall into transmission transfer case.

1.

Using 9/16-inch wrench, unscrew four bolts (1) and take off four locknuts (2).

2.

Lift off cover (3) and take off seal (4). Throw seal away.

3.

Using 7/16-inch wrench, unscrew air vent valve (5) from cover (3).

END OF TASK

9-51