TM-9-2320-209-20-3-1

2½-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; TROUBLESHOOTING; ORGANIZATIONAL LEVEL; VOLUME 3 OF 3; PART 1 OF 4

MAY 1981

TM-9-2320-209-20-3-1 - Page 757 of 830

TM 9-2320-209-20-3-1

FRAME 2

NOTE

Soldier A stands under truck and watches reverse shift rod

lever (1) to see if it moves when soldier B shifts transmission.

Soldier A

1. While watching reverse shift rod lever (1), tell soldier B to shift

transmission into all gears except R (reverse).

Soldier B

2. Put FRONT TRANSMISSION shift lever (2) in position N (neutral).

Soldier A

3. If reverse shift rod lever (1) moved, reverse shift rod (3) must

be shortened as follows:

a.

b.

c.

Soldier B

4. Put

Using 3/4-inch wrench, loosen jamnut (4).

Using 7/16-inch wrench on flat section of reverse shift rod

(3), screw rod into yoke (5).

Using 3/4-inch wrench,

tighten jamnut (4) against yoke (5).

FRONT TRANSMISSION shift lever (2) in position 1 (first

gear).

5.

Do steps 1 through 3 again as needed. Reverse shift rod lever

(1) should be almost ready to move when FRONT TRANSMISSION

gear shift lever (2) goes into neutral (N) position.

GO TO FRAME 3

9-47