TM 9-2320-209-20-3- 2
15-9 .
DRAG LINK ADJUSTMENT .
TOOLS :
Plier s
Screwdriver bi t
SUPPLIES :
Cotter pin (2 )
PERSONNEL: On e
EQUIPMENT CONDITION :
Truck parked, engine off, handbrake set, wheel s
chocked .
1 .
2 .
3 .
4 .
5 .
Lubricate drag link .
Refer to LO 9-2320-209-12/1 .
Using pliers, take cotter pin (1) out of drag link (2) .
Using screwdriver bit , screw in and tighten adjusting plug (3). Unscre w
adjusting plug one-half turn or less, until cotter pin slot lines up with holes .
Put cotter pin (1) through drag link (2). Using pliers, open ends of cotte r
pin .
Do steps 1 through 4 again on other end of drag link (2) .
END OF TAS K
15-30