TM-9-2320-209-20-3-3

2½-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; TROUBLESHOOTING; ORGANIZATIONAL LEVEL; VOLUME 3 OF 3; PART 3 OF 4

MAY 1981

TM-9-2320-209-20-3-3 - Page 456 of 548

TM 9-2320-209-20-3-3

18-83. CAB PROTECTOR UPPER SECTION REMOVAL AND REPLACEMENT

(TRUCK M764).

TOOLS :

None

SUPPLIES :

None

PERSONNEL: Two

EQUIPMENT CONDITION:

Truck parked, engine off, handbrake set.

NOTE

Cab protector may be taken off using truck’s

rear winch and boring machine derrick.

a.

Preliminary Procedures.

(1) Raise derrick from support on cab protector. Refer to TM 9-2320-209-10.

(2) Take out body stakes, bows,

and wheel chocks from stowed positions.

Refer to TM 9-2320-209-10.

b. Removal.

Soldier A 1.

Pull out four pin assemblies (1).

Soldier B 2.

Hook hoist sling (2) to cross bars (3) of protector upper section

(4).

Soldier A 3.

Using guide rope (5), guide cab protector upper section (4) while

it is being lifted off of truck.

Soldier B 4.

Using hoist equipment, lift cab protector upper section (4) off

truck and set it on ground.

5.

Take off hoist sling.

END OF TASK

18-441