TM-9-2320-209-20-3-3

2½-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; TROUBLESHOOTING; ORGANIZATIONAL LEVEL; VOLUME 3 OF 3; PART 3 OF 4

MAY 1981

  TM-9-2320-209-20-3-3 - Page 79 of 548

TM
9-2320-209-20-3-3
h. Assembly of Rack Assembly.
FRAME 1
1.
2.
3.
4.
NOTE
The front part of boards have recesses around the
screw holes to bury the screw head. The back parts
do not have recesses around the screw holes. Board
(1) has eight holes.
Find front part of board (1). Put eight square neck screws (2) through
eight holes in board so screw heads are on front side.
Put square neck screws (2) through end bow packet assemblies (3) and bow
pocket assemblies (4). Using 1/2-inch wrench, start nuts (5) onto square
neck screws.
If screws do not come through enough to start nuts, use
mallet and hammer screws in.
Find front part of board (6), which has 10 holes. Put eight square neck
screws (7) through holes in board so screw heads are on front side.
Put square neck screws (7) through end bow pocket assemblies (3) and
bow pocket assemblies (4). Using
-
1/2-inch wrench, start nuts (8) onto
square neck screws.
If screws do not come through enough to start nuts,
use mallet and hammer screws in.
GO TO FRAME 2
18-64


Back to Top