TM-9-2320-209-20-3-4

2½-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; TROUBLESHOOTING; ORGANIZATIONAL LEVEL; VOLUME 3 OF 3; PART 4 OF 4

MAY 1981

TM-9-2320-209-20-3-4 - Page 219 of 410

TM 9-2320-209-20-3-4

h. Replacement of Right Angle Drive Adapter.

FRAME 1

1.

2.

3.

4.

5.

NOTE

Speedometer right angle drive adapters are supplied

in two different gear ratios. Change parts (1 and 2)

only with parts having same part numbers.

Put sliding drive shaft (1) into right angle drive adapter (2).

Screw sleeve (3) with seal (4) into right angle drive adapter (2) and tighten

using 7/8-inch wrench.

Put drive adapter shaft (5) into hole in transfer case (6). Mesh flat end of

shaft with slot in transfer case.

CAUTION

Make sure lip of rubber seal (4) faces transfer case

(6) to keep oil from leaking.

Carefully screw assembled right angle drive adapter (2) into transfer case

(6) and tighten using 1-inch wrench.

Face right angle drive adapter (2) to best position to take flexible shaft

assembly without bending shaft.

END OF TASK

22-24