TM-9-2320-209-20-3-4

2½-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; TROUBLESHOOTING; ORGANIZATIONAL LEVEL; VOLUME 3 OF 3; PART 4 OF 4

MAY 1981

TM-9-2320-209-20-3-4 - Page 223 of 410

TM 9-2320-209-20-3-4

FRAME 4

Soldier A

Soldier B

Soldier A

NOTE

Some trucks may have speedometer flexible shaft

clamped to floorboards instead of accelerator stop

bolt.

1.

Stand by in cab with 9/16-inch wrench to hold accelerator stop

bolt (1) when soldier B is ready under truck.

2.

Put clamp (2) on flexible shaft (3). Tell soldier A to press down

on stop bolt (1) with fingers.

3.

Put clamp (2) on bolt and screw on locknut (4) with fingers.

CAUTION

Check that flexible shaft (3) is clear of all moving

linkages and free of sharp bends. Move shaft in clamp

as necessary to feed extra slack through cab floor.

4.

Tell soldier A to hold stop bolt (1) with 9/16-inch wrench.

Using 9/16-inch wrench, tighten locknut (4).

5.

Lower pedal (5) and put connecting link (6) through hole in

pedal. Using pliers, put cotter pin (7) through hole in end of

connecting link and bend open ends of cotter pin.

GO TO FRAME 5

22-28