TM-9-2320-209-20-3-4
2½-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)
TECHNICAL MANUAL; TROUBLESHOOTING; ORGANIZATIONAL LEVEL; VOLUME 3 OF 3; PART 4 OF 4
MAY 1981
TM-9-2320-209-20-3-4 - Page 61 of 410
TM 9-2320-209-20-3-4
19-10. FRONT, MID, AND REAR WINCH CABLE AND CHAIN ASSEMBLY REMOVAL,
REPAIR, AND REPLACEMENT.
NOTE
This task shown is for the mid winch cable and
chain assembly. This task is the same for the
front and rear winch cable and chain assemblies.
TOOLS:
3/8-inch socket head screw key Wire cutters
(Allen wrench or equivalent) Hammer
12-inch ruller Soft-jawed vise
Leather gloves Adjustable wrench (2)
SUPPLIES:
Solvent, dry cleaning, type II (SD-2), Fed. Spec P-D-680
Clean rags
Clevis assembly
Seizing
PERSONNEL:
One
EQUIPMENT CONDITION:
Truck parked, engine off, handbrake set.
WARNING
Always wear protective gloves when handling
winch cable. Do not let winch cable slip
through hands.
Rusty or broken wires can
cause serious injury.
a. Preliminary Procedure. Unwind winch cable to the end. Refer to TM
9-2320-209-10.
19-48
Back to Top
