TM-9-2320-209-20-3-4
2½-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)
TECHNICAL MANUAL; TROUBLESHOOTING; ORGANIZATIONAL LEVEL; VOLUME 3 OF 3; PART 4 OF 4
MAY 1981
TM-9-2320-209-20-3-4 - Page 56 of 410
TM 9-2320-209-20-3-4
19-9. REAR WINCH DRUM CLUTCH LEVER AND GUIDE PLATE
AND REPLACEMENT (TRUCK M756A2).
TOOLS:
Hammer
1/8-inch punch
9/16-inch wrench
Flat-tip screwdriver
Five-foot prybar
Vise
REMOVAL, REPAIR,
SUPPLIES:
Solvent, dry cleaning, type II (SD-2), Fed. Spec P-D-680
PERSONNEL: Two
EQUIPMENT CONDITION:
Truck parked, engine off, handbrake set.
a. Removal.
FRAME 1
1.
Working in between cab protector and cab and using hammer and punch,
drive out pin (1) holding drum clutch lever (2) to clutch shaft (3).
2.
Using 9/16-inch wrench, unscrew and take out two screws, lockwashers,
and flat washers (4) from guide plate (5).
3.
Take off data plate (6) and guide plate (5).
4.
Using screwdriver, pry drum clutch lever (2) from clutch shaft (3). Take
out drum clutch lever (2).
END OF TASK
19-43
Back to Top
