TM-9-2320-209-34-2-2

2½-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; MAINTENANCE; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 3

MAY 1981

TM-9-2320-209-34-2-2 - Page 545 of 899

TM 9-2320-209-34-2-2

FRAME 15

Soldier A 1.

Balance rack bar (1) when soldier B feeds it into boring gear

case (2).

Soldier B 2.

Using boring machine, feed rack bar (1) into boring gear case (2)

until approximately two feet are out top of rack carrier tube (3).

Refer to Operation of Earth Boring Machine and Polesetter Trucks,

TM 9-2320-209-10.

NOTE

Be sure the thinnest plate (4) goes on the shortest stud (5).

3.

Put four plates (4) in plate retainer (6).

NOTE

Be sure the thinnest plate (4) is against rack bar (1) teeth.

4.

Slide plate retainer (6) with four plates (4) over rack bar (1)

and put in plate.

NOTE

Spacers (7) must be the same thickness as noted in removal.

5.

Put on spacers (7) and rack carrier nut (8).

6.

Put in two capscrews (9).

GO TO FRAME 16

17-528