TM-9-2320-209-34-2-3

2½-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; MAINTENANCE; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 3 OF 3

MAY 1981

TM-9-2320-209-34-2-3 - Page 214 of 592

TM 9-2320-209-34-2-3

h.

Replacement.

FRAME 1

Soldiers

A and B

Soldier A

Soldier B

Soldiers

A and B

Soldier A

Soldier B

CAUTION

Bypass tubes on outside of hoist cylinder assembly (1)

are easily damaged. Be careful when replacing hoist

cylinder assembly.

1.

Lift hoist cylinder assembly (1) into place on truck. Seat pin of

hoist cylinder assembly in two bearing seats (2).

2.

Place wood block under end of cylinder assembly (1).

3.

Put two bearing caps (3) in place.

4.

Put in four screws and lockwashers (4).

5.

Slide piston rod (5) into bore in crosshead (6). Line up groove in

piston rod with slots in crosshead.

6.

Hold hoist cylinder assembly (1) in place.

7.

Put upper retainer (7) in slot in crosshead (6) and hold lower

retainer (8) in place in slot in crosshead.

8. Put in two screws and lockwashers (9).

GO TO FRAME 2

18-203