TM-9-2320-209-34-2-3

2½-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; MAINTENANCE; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 3 OF 3

MAY 1981

TM-9-2320-209-34-2-3 - Page 222 of 592

TM 9-2320-209-34-2-3

FRAME 2

1.

2.

3.

4.

5.

6.

7.

NOTE

Put wear plates (1 and 2) back in same positions noted.

Press two bearings (3) into bores in rear end cover (4). Refer to Part 1,

para 10-8.

Put wear plate (1) in place against rear end cover (4). Take care not to

scratch or nick wear plate.

Put in two guide pins (5).

Put pump body (6) on guide pins (5) and push it in place against

plate (1).

Notch on pump body must be on same side as notch on

cover (4).

wear

rear end

Put drive shaft assembly (7) and driven shaft assembly (8) into bores of

bearings (3). Take care not to scratch or nick bearings or shafts.

Put in two guide pins (9).

Put wear plate (2) on drive shaft assembly (7) and driven shaft assembly (8)

and push it onto guide pins (9) in pump body (6). Take care not to scratch

or nick wear plate.

GO TO FRAME 3

18-211