TM-9-2320-209-34-2-3

2½-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)

TECHNICAL MANUAL; MAINTENANCE; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 3 OF 3

MAY 1981

TM-9-2320-209-34-2-3 - Page 229 of 592

TM 9-2320-209-34-2-3

18-11. POWER DIVIDER INPUT AND REAR OUTPUT SHAFT OIL SEALS REMOVAL

AND REPLACEMENT (TRUCK M764).

NOTE

This task is the same for the input shaft and rear

output shaft oil seals.

This task is shown for the

input shaft oil seal.

TOOLS:

No special tools required

SUPPLIES:

Cotter pin

Clean rags

Solvent, dry cleaning, type II (SD-2), Fed. Spec P-D-680

Gear lubricating oil, GO 80/90, MIL-L-2105

Input shaft oil seal

Rear output shaft oil seal

PERSONNEL: One

EQUIPMENT CONDITION:

Truck parked, engine off, handbrake set.

18-218