TM-9-2320-209-34-2-3
2½-TON, 6X6, M44A1 AND M44A2 SERIES TRUCKS (MULTIFUEL)
TECHNICAL MANUAL; MAINTENANCE; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 3 OF 3
MAY 1981
TM-9-2320-209-34-2-3 - Page 63 of 592
TM 9-2320-209-34-2-3
FRAME 6
1.
Check that lining on drag brake (1) or drive worm brake (2) is not scored, burned,
oil soaked or worn down to rivets (3).
Take off damaged brake lining and rivets and
get new ones in their place.
2.
Put new lining (4) on drag brake (1). Put in two brass tubular rivets (3).
3.
Put new lining (5) on drive brake (2). Put one rivet (3) at each end of band. Put in
every other rivet until all rivets are put on.
4.
Check that surface of drive worm brake disk (6) is not scored or rough. If brake disk
is damaged, get a new one.
GO TO FRAME 7
8-52
Back to Top
