TM-9-2320-260-20
TRUCK, 5-TON, 6X6, M809 SERIES (DIESEL)
TECHNICAL MANUAL; UNIT MAINTENANCE
APRIL 1995
TM-9-2320-260-20 - Page 1189 of 1337
TM 9-2320-260-20
Section V. MlNI LIGHTING KITS MAINTENANCE
14-37. MINI LIGHTING KITS MAINTENANCE INDEX
I
PARA.
TITLE
PAGE
NO.
NO.
14-38.
Intermediate Turn Signal Light Replacement
14-72
14-39.
Front and Rear Side Marker Lights Replacement
14-74
I
14-38. INTERMEDIATE TURN SIGNAL LIGHT REPLACEMENT
THIS TASK COVERS:
a. Removal
b.Installation
INITIAL SETUP
APPLICABLE MODELS
REFERENCES (TM)
All
TM 9-2320-260-10
MATERIALS/PARTS
Two O-rings
TM 9-2320-260-20P
EQUIPMENT CONDITION
Two screw-assembled lockwashers
• Parking brake set (TM 9-2320-260-10).
Four locknuts
• Battery ground cable disconnected (para. 4-48).
Seal
Lockwasher
a. Removal
1.
Remove two lenses (2), O-rings (3), and lamp (1) from lamp housing (4). Discard O-rings (3).
2. Remove four locknuts (11), screws (8), and cover (13) from fender (10) and hood (9). Discard
locknuts (11).
3. Disconnect lead (15) from wire (14).
4. Remove grommet (7) from lead (15), leads (12), and fender (10).
5. Remove nut (17), lockwasher (18), lamp housing (4), and seal (5) from brushguard (6). Discard
lockwasher (18) and seal (5).
6. Remove two screw-assembled lockwashers (16) and brushguard (6) from hood (9). Discard screw-
assembled lockwashers (16).
I
b. Installation
NOTE
Ensure red lens on intermediate turn signal light is installed
facing rear of vehicle.
1. Install brushguard (6) on hood (9) with two new screw-assembled lockwashers (16).
2. Install new seal (5) and lamp housing (4) on brushguard (6) with new lockwasher (18) and nut (17).
3. Insert lead (15) through hole in fender (10) and connect to wire (14).
4. Place grommet (7) around lead (15) and leads (12), and install on fender (10).
14-72
Back to Top
