TM-9-2320-260-20
TRUCK, 5-TON, 6X6, M809 SERIES (DIESEL)
TECHNICAL MANUAL; UNIT MAINTENANCE
APRIL 1995
TM-9-2320-260-20 - Page 1213 of 1337
TM 9-2320-260-20
Section X. CONVOY WARNING LIGHT KIT MAINTENANCE
14-50. CONVOY WARNING LIGHT KIT MAINTENANCE INDEX
PARA.
TITLE
PAGE
NO.
NO.
14-51.
Convoy Warning Light Mount Replacement
14-96
14-52.
Convoy Warning Light Mount (M820, M820A1, M820A2) Replacement
14-100
14-53.
Convoy Warning Light Mount (M817) Replacement
14-102
14-54.
Convoy Warning Light Harness Replacement
14-104
14-55.
Convoy Warning Light Harness (M817) Replacement
14-106
14-56.
Convoy Warning Light Harness (M820, M820A1, M820A2) Replacement
14-108
14-57.
Convoy Warning Light Resistor and Leads Replacement
14-110
14-58.
Convoy Warning Light Replacement
14-112
14-59.
Convoy Warning Light Switch Replacement
14-114
14-51. CONVOY WARNING LIGHT MOUNT REPLACEMENT
THIS TASK COVERS:
a. Removal
b. Installation
INITIAL SETUP
APPLICABLE MODELS
REFERENCES (TM)
All (except M817, M820, M820A1, M820A2)
TM 9-2320-260-10
MATERIALS/PARTS
TM 9-2320-260-20P
Nine locknuts
EQUIPMENT CONDITION
Screw-assembled lockwasher
• Parking brake set (TM 9-2320-260-10).
• Convoy warning light removed (para. 14-58).
NOTE
The left and right convoy warning light mounts are replaced the
same way. This procedure covers the left light mount only.
1. Disconnect two leads (13) from connectors (14).
2. Remove screw-assembled lockwasher (12), washer (11), clamp (10), and cable (22) from gun mount
bracket (9). Discard screw-assembled lockwasher (12).
3. Remove cable (22) from mounting plate (1) and support tube (2).
4. Remove wing screw (20), pin (21), and support tube (2) from bracket tube (16) and bracket (19).
5. Remove two locknuts (18), washers (17), U-bolt (6), locknut (5), washer (4), screw (3), and
bracket (19) from bracket tube (16). Discard locknuts (5) and (18).
14-96
Back to Top
