TM-9-2320-260-34-1

TRUCK, 5-TON, 6X6, M809 SERIES (DIESEL)

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE; VOLUME 1 OF 2

JULY 1994

TM-9-2320-260-34-1 - Page 175 of 657

TM 9-2320-260-34-1

3-41. CAM FOLLOWERS REMOVAL

THIS TASK COVERS:

Removal

lNITIAL SETUP

APPLICABLE MODELS

REFERENCES (TM)

All

TM 9-2320-260-34P-1

TOOLS

EQUIPMENT CONDITION

General mechanic’s tool kit

(Appendix B, Item 1)

l Accessory drive removed (para. 3-32).

l Rocker lever housings and push tubes removed

(para. 3-37).

NOTE

l All cam followers are removed the same. This procedure is for

one cam follower.

l Gasket thickness between cam follower housing and cylinder

block controls injector timing. Measure and record thickness of

each gasket before discarding.

1. Remove six screws (4) from housing (3).

2. Carefully pry housing (3) from two dowels (1) and remove housing (3), gasket (6), and cam

follower (5) from cylinder block (2). Measure and record gasket (6) thickness. Discard gasket (6).

NOTE

For disassembly, cleaning, inspection, repair, and assembly, refer

to para. 3-19.

3-123