TM-9-2320-272-23-2
TRUCK, 5-TON, 6X6, M939, M939A1, AND M939A2 SERIES TRUCKS (DIESEL)
TECHNICAL MANUAL; FIELD MAINTENANCE MANUAL; VOLUME 2 OF 5
SEPTEMBER 2012
TM-9-2320-272-23-2 - Page 1320 of 1417
INSTALLATION
NOTE
•
Male pipe threads must be wrapped with antiseize tape before installation.
•
Steps (1) and (2) are for M939/A1 models only.
1.
Install elbow (Figure 2, Item 4) on left side of engine (Figure 2, Item 3).
2.
Install adapter fitting (Figure 2, Item 5) on elbow (Figure 2, Item 4).
3.
Install oil pressure sending unit (Figure 2, Item 2) on adapter fitting (Figure 2, Item 5).
4.
Connect wire (Figure 2, Item 1) to oil pressure sending unit (Figure 2, Item 2).
5
1
2
1
2
M939/A1 VEHICLES
M939/A2 VEHICLES
5
4
3
M0210DAA
Figure 2.
Oil Pressure Sending Unit Installation.
END OF TASK
FOLLOW-ON MAINTENANCE
1.
Install left splash shield. (TM 9-2320-272-10)
2.
Connect battery ground cables. (WP
0350)
3.
Start engine and check oil pressure sending unit operation. (TM 9-2320-272-10)
END OF TASK
END OF WORK PACKAGE
TM 9-2320-272-23-2
0333
0333-3/4 blank
Back to Top
