TM-9-2320-272-23-2

TRUCK, 5-TON, 6X6, M939, M939A1, AND M939A2 SERIES TRUCKS (DIESEL)

TECHNICAL MANUAL; FIELD MAINTENANCE MANUAL; VOLUME 2 OF 5

SEPTEMBER 2012
TM-9-2320-272-23-2

  TM-9-2320-272-23-2 - Page 907 of 1417

REMOVAL
NOTE
•
Throttle control cable maintenance for all vehicles is basically the same. This procedure
covers M939/A1 series vehicles.
•
Throttle cable end may have to be straightened before performing Step (1).
1.
Remove screw (Figure 1, Item 25) and connector (Figure 1, Item 23) from throttle cable (Figure 1, Item 26).
2.
Remove throttle cable (Figure 1, Item 26) from throttle rod link (Figure 1, Item 24).
NOTE
Perform Step (3) for unmodified throttle routing (throttle cable on bracket). Perform Step (4)
if throttle cable clamp is mounted on firewall.
3.
Remove locknut (Figure 1, Item 12), washer (Figure 1, Item 11), conduit clamp (Figure 1, Item 14), and screw
(Figure 1, Item 15) from bracket (Figure 1, Item 9) on firewall (Figure 1, Item 10). Discard locknut.
4.
Remove screw (Figure 1, Item 16), conduit (Figure 1, Item 13) with clamp (Figure 1, Item 17), wire harness
(Figure 1, Item 18) with clamp (Figure 1, Item 19), washer (Figure 1, Item 20), ground strap
(Figure
1,
Item
21), and lockwasher (Figure 1, Item 22) from firewall (Figure 1, Item 10). Discard lockwasher.
5.
Pull conduit (Figure 1, Item 13) and throttle cable (Figure 1, Item 26) through grommet (Figure 1, Item 1) in
firewall (Figure 1, Item 10) and into vehicle cab.
6.
Remove grommet (Figure 1, Item 1) from firewall (Figure 1, Item 10).
7.
Remove four screws (Figure 1, Item 4) from throttle control plate (Figure 1, Item 7) and instrument panel
(Figure
1, Item
2).
8.
Remove nut (Figure 1, Item 3), lockwasher (Figure 1, Item 8), and plate (Figure 1, Item 7) from throttle control
(Figure 1, Item 6). Discard lockwasher.
9.
Remove throttle control (Figure 1, Item 6), plate (Figure 1, Item 7), and conduit (Figure 1, Item 13) from
instrument panel (Figure 1, Item 2).
NOTE
Perform Step (10) if throttle control is to be replaced.
10.
Remove throttle control handle (Figure 1, Item 5) and cable (Figure 1, Item 26) from conduit
(Figure
1,
Item
13).
TM 9-2320-272-23-2
0270
0270-2


Back to Top