TM-9-2320-272-23-2

TRUCK, 5-TON, 6X6, M939, M939A1, AND M939A2 SERIES TRUCKS (DIESEL)

TECHNICAL MANUAL; FIELD MAINTENANCE MANUAL; VOLUME 2 OF 5

SEPTEMBER 2012
TM-9-2320-272-23-2

  TM-9-2320-272-23-2 - Page 913 of 1417

REMOVAL
NOTE
Steps (1) through (4) are for M939A2 series vehicles.
1.
Remove lock pin (Figure 1, Item 10), washer (Figure 1, Item 11), and cable pivot (Figure 1, Item 4) from shutoff
valve lever (Figure 1, Item 1). Discard lock pin.
2.
Remove screw (Figure 1, Item 2), connector (Figure 1, Item 3), and cable pivot (Figure 1, Item 4) from cable
(Figure 1, Item 5).
3.
Remove screw (Figure 1, Item 9), clamp (Figure 1, Item 7), and cable conduit (Figure 1, Item 6) from fuel
bracket (Figure 1, Item 8).
4.
Remove clamp (Figure 1, Item 7) from conduit (Figure 1, Item 6).
NOTE
Steps (5) through (9) are for M939/A1 series vehicles.
5.
Remove connector screw (Figure 1, Item 18) and connector (Figure 1, Item 19) from shutoff valve control lever
(Figure 1, Item 28) and cable (Figure 1, Item 5).
6.
Remove connector (Figure 1, Item 19) from stop control cable (Figure 1, Item 5).
7.
Remove locknut (Figure 1, Item 24), washer (Figure 1, Item 25), and screw (Figure 1, Item 21) from clamp
(Figure 1, Item 20) on conduit (Figure 1, Item 6) and conduit clamp bracket (Figure 1, Item 26). Discard locknut.
8.
Remove screw (Figure 1, Item 23), lockwasher (Figure 1, Item 22), and clamp bracket (Figure 1, Item 26) from
engine (Figure 1, Item 27). Discard lockwasher.
9.
Remove clamp (Figure 1, Item 20) from conduit (Figure 1, Item 6).
NOTE
Steps (10) through (13) applies to all vehicles.
10.
From behind instrument panel (Figure 1, Item 15), remove nut (Figure 1, Item 12) and lockwasher
(Figure
1,
Item
13) on emergency stop control (Figure 1, Item 14). Discard lockwasher.
11.
Pull emergency stop control (Figure 1, Item 14), conduit (Figure 1, Item 6), and cable (Figure 1, Item 5) through
firewall (Figure 1, Item 17), grommet (Figure 1, Item 16), and front of instrument panel (Figure 1, Item 15).
12.
Remove grommet (Figure 1, Item 16) from firewall (Figure 1, Item 17).
NOTE
Perform Step (13) only if replacing stop control cable.
13.
Remove stop control cable (Figure 1, Item 5) and handle of stop control (Figure 1, Item 14) from conduit
(Figure
1,
Item
6).
TM 9-2320-272-23-2
0271
0271-2


Back to Top