TM-9-2320-272-23-2
TRUCK, 5-TON, 6X6, M939, M939A1, AND M939A2 SERIES TRUCKS (DIESEL)
TECHNICAL MANUAL; FIELD MAINTENANCE MANUAL; VOLUME 2 OF 5
SEPTEMBER 2012
TM-9-2320-272-23-2 - Page 919 of 1417
REMOVAL
1.
Remove cotter pin (Figure 1, Item 1) and washer (Figure 1, Item 2) from accelerator pedal push rod
(Figure
1,
Item 13). Discard cotter pin.
2.
Remove hinge pin (Figure 1, Item 7) and accelerator pedal (Figure 1, Item 3) from accelerator pedal bracket
(Figure 1, Item 5).
3.
Remove two screws (Figure 1, Item 4) and bracket (Figure 1, Item 5) from cab floor (Figure 1, Item 6).
4.
Remove cotter pin (Figure 1, Item 12), washer (Figure 1, Item 10), and accelerator pedal rod
(Figure
1,
Item
13) from link assembly (Figure 1, Item 11). Discard cotter pin.
5.
Loosen jamnut (Figure 1, Item 9) above cab floor (Figure 1, Item 6) and remove accelerator pedal stopscrew
(Figure 1, Item 8).
6.
Remove jamnut (Figure 1, Item 9) from pedal stopscrew (Figure 1, Item 8).
M0097DAA
13
2
1
3
4
5
7
6
8
9
10
11
12
Figure 1.
Accelerator Pedal Removal.
END OF TASK
INSTALLATION
1.
Install jamnut (Figure 2, Item 9) on pedal stopscrew (Figure 2, Item 8) to limit of threads.
2.
Install pedal stopscrew (Figure 2, Item 8) on cab floor (Figure 2, Item 6) and tighten jamnut (Figure 2, Item 9)
against cab floor.
3.
Install accelerator pedal bracket (Figure 2, Item 5) on cab floor (Figure 2, Item 6) with two screws
(Figure
2,
Item 4).
4.
Install accelerator pedal (Figure 2, Item 3) on bracket (Figure 2, Item 5) with hinge pin (Figure 2, Item 7).
5.
Install accelerator pedal push rod (Figure 2, Item 13) on accelerator pedal (Figure 2, Item 3) and link assembly
(Figure 2, Item 11) with washers (Figure 2, Items 2 and 10) and cotter pins (Figure 2, Items 1 and 12). Spread
ends of cotter pins after adjustment.
TM 9-2320-272-23-2
0272
0272-2
Back to Top
